Recent content by Bass_boy7

haha took ya bit to figure out that short form eh haha, anyways I have a deep v hull and its great for the waters i fish, larger lakes etc no complains and lots of room to move around and its not hard to build some decking on them.

if you want afew laughs go visit www.unitedpackagesmashers.com its a site dedicated to those who work there have worked there and the stories and ideas shared in the forum

oh ok thanks alot, wasn't sure if for some reason it would make the metal more suseptable to rusting, but i guess aluminum doesn't really rust on these boats. thanks again.

Hey guys I don't mean to jump into your thread, sorry in advance I was wondering if its ok to just strip the paint off my boat and run it the natural aluminum colour? is there any problems with this or anything?

wow guys thanks for all the information I definately am going to really review how my boat is set up and decide on the proper move to ensure safety and to allow me to move around it without tripping or fumbling over all the seats , any more input is always welcomed.

yea i think if i do take it out I will re-enforce the floor where the seat was below my decking. i have seen pics of one without the middle seat but i don't know waht the person did as it was a for sale add in texas i think lol

yes my boat is exactly the same as yours the deep v hull but the 14', so you feel its not a vital part of it? I want it out so I can make a descent floor to walk/cast from, then create a casting deck front and rear of the boat.

hello everyone I need some help, I have a 14' mirrocraft aluminum boat, I have the 3 bench seats in it, I am looking to remove the middle seat to create some more walking room, and I would be installing a floor from front to back. I was wondering how I go about doing it so I don't ruin my boat...