hey i edended up going with intrlux 2000e pait its a little more but should holde up better i got a gallon of paint and shoud do the hole thing easy. it was only a 100 bucks +/- it seam to bee the best solution. i thing will let you know how it goes.
Hay u might run into problems with that dimond plate on the back of the transom like that. U want it to bight into that peace of wood on the back of the transom on the out side. As for the peace on the inside of the boat that one should be good and help keep bolts from maring up the transom. As...
hay i dont think that is a four stroke but a oil injected 2 stroke judging but the pic of the engine were the cover is off. so that alarm could be low fuel oil or hi temp alarm. if it is a high temp alarm you should replace the impeller for the cooling system it should only take a little bit to...
you want to make sure to clean up the mettle and with a wire weal or something and get it as clean as possible. post some pic of what your talking about and of the inside. it wouldn't mess up the cock but if its in bad shape you might want to remove it then replace it after you put the gluevit down.
you want to make sure to clean up the mettle and with a wire weal or something and get it as clean as possible. post some pic of what your talking about and of the inside. it wouldn't mess up the cock but if its in bad shape you might want to remove it then replace it after you put the gluevit down.
you can find it on iboats.com here https://www.iboats.com/Boat-Parts-Accessories/dm/cart_id.447932903--keywords.gluvit--searched.1--session_id.937450372--submit.Search--submit%2Ex.0--submit%2Ey.0 stuff works really well but can be a pain to work with if you use it u must paint over the top as...
you can find it on iboats.com here https://www.iboats.com/Boat-Parts-Accessories/dm/cart_id.447932903--keywords.gluvit--searched.1--session_id.937450372--submit.Search--submit%2Ex.0--submit%2Ey.0 stuff works really well but can be a pain to work with if you use it u must paint over the top as...
i have had a blast this week building on my boat. i have managed to get all the carpet done and the inside pated with dark gray hammer finish turned out real nice. i also got most of my aluminum in with brass screws locks real sharp. i am real happy with the way it is turning out. i also...
first of nice score should be lot of fun. If the holes are small u can use some jb weld on them. the other thing you can do is weld them up. i used a TIG welder on mine but if i did not have access to a welder i would have used TB-weld. the other thing i would recommend is using gluevit (SP) on...
One thing I have not put much thought into was paint for the out side of the boat. I have seen a few people use stealflex and a few people that used oil based paint from rustolium. I was wondering about durability of boath and which one is better as fare as quality durability and any other...