Recent content by Broncoxlt

more pics

pics

Pics

2015 Alumacraft 1648 Sierra 2015 Yamaha 25 LEHB approx 75 hrs 2015 Road King galvanized trailer Open floor plan minnkota v2 powerdrive Livewell/cooler wired nav lights fused switch panel. Rod holders. 6500 with out electronics 7000 with lowrance elite 5 ti total scan and hook 5

Heres what i did to mine to mount my fish finder and trolling motor. Started off just riveted the frame to the boat but the weight of the trolling motor bouncing broke the angle frame work rebuilt it and a buddy welded it for me https://forum.tinboats.net/viewtopic.php?f=3&t=37621&start=15

The 5 ti was bought by my fishing partner its a nice unit but if I was going to buy one I would get the 7 with all the features the 5 screen is to small. and the ti transducer is huge it will not fit on the trolling motor. I am going to get an elite 5 hook to use on the front and move the ti to...

There was foam under the front deck it was 3 pieces one on each side of the storage area and one the width of the storage area. I removed the one and left the other 2. The back pod areas in my boat are about 90 filled for the power to the fuse pannel and fuses I removed enough to get the ob done...

well got this wanna be bass boat just about done. cooler livewell, switch panel, Elite 5 ti installed and rod holders

Finally got some more work done got the sheet cut for the trolling motor mount and cut the front battery hatch.

this is last cooler livewell I made for my last boat worked great used a bucket to fill or a separate bildge pump tossed over the side with the wires running zip tied to the tubing back to the cooler https://forum.tinboats.net/viewtopic.php?f=21&t=12550&start=45

The wire is ran through the top rail to where the v starts then run just under the rail in some 1/4 sprinkler lines to the lights. I wanted to run it in the rail all the way but due to the weld and rail is split and comes over the sides of the boat it would not make that first v bend. if you...

I have used stacked 2x10s from the factory deck to raise the trolling motor up and made a frame from aluminum angle and made a small deck for my V2 to mount in my new boat. https://forum.tinboats.net/viewtopic.php?t=12550 new front deck with stacked plywood page 2...

thanks lowe was short lived due to family issues. Great boat but the alumacraft is nicer for sure

got some work done trolling motor and lights mounted. Still need to cut the sheet to cover the frame

thanks guys. got the boat out an finished up the last part for the 2 hour break in afterward with about 500 lbs worth or people andgear ran about 28mph by gps speedometer on my phone plenty fast enough for me. ow time to bild the trolling motor mount and rig the lights.