The guy who I bought my boat from used 2 pieces of composite board. I don't expect the need to replace it. Just an option
Sent from my iPhone using Tapatalk
Great project! I am a week into my 14' modification. Looks like you have a lot more work than me, but I also had 4 small leaks in the bottom. I found that out by flooding the boat about 3 inches. I just took a metal angle grinder brush to it lightly to get a great contact area for the JB weld I...
So I am beginning the floor construction and have gone with a rubber mat, but need 1 1/2" insulation board. Apparently they only sell 1 1/2" in the north. I know I can always glue two 3/4" together, but I was trying to keep cost and work down. Anyone know where to get 1 1/2" board in Florida...
The first 2' section I used a heatgun at 1200 degrees, it took about 20 mins for that one section. I recommend not using the heatgun. Switching over to a handheld torch i completed each 2' section in about 5 mins. I have to say the finished cure of the bamboo looks amazing and best of all it was...
The previous owner used it for flounder giggin, the 6 1/2' long front deck with stainless hinge is in great condition
Sent from my iPhone using Tapatalk
This is my first Jon boat. I purchased it out of Jacksonville via Craigslist for $750 for the hull and trailer with no motor. Fortunately I have a 1996 20hp outboard mariner from a zodiac that we used a handful of times. Ever since the motor has been garage kept.
Here are a few pictures of the...