Recent content by diabetik11

Ok I'm usually a Johnson guy but got a killer deal on this merc and just seemed like my Johnson I had sat lower in water. And when I get going up to full throttle it seems like it cuts out but doesn't die so idk cause it runs and idles good and pumps water good

This is mine seems like it should go lower

I got a 87 mirrocraft deep fisherman 2 and a 87 25 hp Mercury but my problem is that the cavitation plate on the motor is like 2inches above the bottom of the boat. How can I lower it with out having to cut the transom down and I don't want to have to get a new boat or motor. I can take a pic if...

i am going to go look at a 1993 tracker tad pole 12ft tomorrow and i think he is asking a little much just wondering what you guys think. hes asking $1300 for just the boat and trailer. the boat is in like new condition with only a trolling motor put on it once and then took off. does anyone...

what is the big difference between the 2, i needed some nuts, bolts and washers for my trailer bunk brackets, so i got 3/8 galvanized bolts and lock washers and stainless steel washers and nuts, i would have got all galvanized to match my trailer but couldn't, mixing stainless and galvanized...

i am in need of some nuts and bolts for my galvanized trailer also and went to menards tonight and got galvanized bolts and then got stainless nuts and washers cause there where no galvanized nuts and washers or at least i could not find them

i just got this trailer and noticed that the tounge on it has a little twist/bend to it nothing major the trailer pulls straight and fine but i can tell its there. just wondering if i am able to bend it back to being straight or have a metal shop do it for me its a 2x3 tubing and its galvanized.

yea that broom clip was what i was looking for thanks

hey frogmann what did you use to hold the transom light to the bench with, i got the same light just cant figure how to store it any where and i like ur idea, i have my bow light permnantly on my boat and i dont want to permenantly mount the transom light

i just got a Minn kota 105P charger and am wondering if this is a good one for my deep cycle interstate battery its a size 24 battery, can u leave this charger plugged into the battery all the time and it wont hurt the battery at all correct. the charger is a 5 amp its the little round one with...

i have one that i am looking to sell it has to trolling motors a bow and a transom mount and a swivel seat, spartan trailer asking $700 its in really good shape for its age

so i started to put a deck in tonight, its a different kind of deck its level with the seats, pictures will explain the rest, i used a piece of angle aluminum to hold it up, i screwed a piece to each bench and then put the deck on those, i bolted the deck to the angle aluminum then seems sturdy...

johny25 i want to but i think there will be just to much weight up front with me a bow mount and the battery, anyone have any pic of how they mounted there bow mount motor to the front of the boat

ok i changed my mind i might just put a flat floor in it and maybe a deck in the back by the motor, but i need to figure out how to attach a bowmount to the boat any ideas?

i got a old 12ft alumacraft this spring and i like it a lot it is a model R7 rated for a 20hp motor, does anyone know what year this could be. i got a 15hp evinrude for it. so i have been fishing out of it a lot and i want to finally do some mods to it nothing big but i want to put a casting...