I have nowhere near to the patience needed to do a build like that. I was fishing out of mine as soon as I could. Still working on it it, but fishing out of it.
Updated picture....and a question.
It came with a 25 horse evinrude, but i put it in the shop to get it ready and they replaced an engine coil and just found out that the flywheel is cracked too. I'm running low on funds so I am considering putting it on craigslist for a trade with a working...
This is my boat. It came with a 25 horse evinrude, but i put it in the shop to get it ready and they replaced an engine coil and just found out that the flywheel is cracked too. I'm running low on funds so I am considering putting it on craigslist for a trade with a working outboard of lower HP...
Well, first I stripped out the silicon, which was just spread thick.....everything white/light gray on the hull was silicon. Then I sprayed on some rustoleum non skid in all the cracks and over each rivit. Then painted with 3 thick coats on the outside over the aluminum primer and the same on...
The foam looks a lot cheaper...I may try it.
Below is my boat...after my friends pranked it.... :shock:
Of course, my neighbors are lesbians too...so I painted that over asap.
Thanks man, I will...
Question for everyone...I'm going to put a deck in, but I have been thinking more and more about what I can do without putting on carpet. What do you think about this...