Here's what i've been using for about 5 years now.
https://www.lavacoreinternational.com/lavacore-long-sleeve-shirt-male/
https://www.lavacoreinternational.com/lavacore-pants-unisex/
https://www.lavacoreinternational.com/lavacore-socks/
i initially bought for jet skiing and m/c riding, but i...
im soooo sorry i took so long to reply.....thank you and yes sbt the "jet ski" place. it is in the "sheet goods" traction pad here.... https://www.shopsbt.com/jet-skis/blacktip-sheet-goods.html
It's been ages since i've made a trotline and looking to hear what knots you all are using to tie the leader lines to the swivels. i picked up 75 of the spring tension main line clips, so since there's an open end i was thinking a palomar knot would be ok. Or is there something better...
went out last night initially to just see how the hull sat in water/ where fuel tank needed placed/if battery needed moved. About the setup, nothing fancy at all just a poor mans 1436 2001 alumacraft rivet, swomp23, 2 x 6 gal fuel tanks, one group 29 batt, one little lawn tractor batt, a 45lb...
ok so i read you retrieved the fish, but while you were down there did you remember to get your socket?? i had a 5 spd truck that had a socket somehow get under the drivers carpeting and into the sub flooring...every shift the darn thing would roll back and forth making all sorts of...
below is how the livewell is set up, mind you i have never done a boat livewell before and after seeing some done the goal was to make something very simple. i want to know if this is correct please.
Green = thru hull fittings for 3/4" hose
Blue = 3/4" hose
Puprle = livewell aerator pump...
Thanks, yes the plan was stainless just didn't know which was preferrd to use. Picked up a lil something from freight yesterday.
It actually came boxed I had already removed it.
Transom bracket mounted up
And finally it has an engine
The fuel tank wont be staying in that location, its...
Quick question, how should flooring be fastened to the hull? Screws or rivets? If screws, self tapping or just predrill? Sorry for the newbie question, but this is the first time i've done a floor.
Here's the turf/tarction matting https://www.shopsbt.com/jet-skis/traction-mats-seat-covers.html it is " sheet goods" under the jet ski mat selection.
The diamond plate is 5mm thick and goes to 7-8mm where it is raised for the plating heights. It gets warm but not what I call hot or near...