Recent content by MakeItHappen

I agree with this. I bought mine from Red Leg Camo https://www.redlegcamo.com/#!camo-stencils/c8z9. I like them, but the stencils were so thin that once too much paint got on them from the spray can, they would get super flimsy and didn't hold up terribly well. I used the camo colors of spray...

I picked up a cutting board from goodwill (no sense in paying full price) and cut it in half, then JB welded it with clamps overnight. I then drilled through the cutting boards, marked and drilled the holes in the boat. I put JB weld on the back of the cutting board and used fine threaded size...

Yep. I used two fine threaded size 10 screws with rubber/metal washers on both sides before putting a lock nut on each. Pretty happy with the results.

Because the wire loom didn't offer solid enough protection for what I was looking for. I deer and duck hunt out of this boat along with bowfishing and regular fishing, so I wanted a setup that would hold up to the abuse. I used the cutting board as I wasn't 100% sure of the best location for...

I've been a longtime lurker of the site and wanted to post up my electrical project. I realize this could fit in the Boat House as a mini-project, but it was an electrical project and I've seen a bunch of questions and learned a ton from the Electrical forum. This boat had zero electrical when...

Looks good.

Heck of a deal! Best of luck keeping it an inverted bathtub!

Awesome, thanks paper!

Paper, can you provide a link to the lights you used on the inside of your boat? They appear to be the Atwood 4 LED lights, but I'm not sure and I'm wanting to do the same to my boat.

Very nice progress.

Looking good! I was considering getting an angle welded to my transom in the middle, much like your's, to relieve some of the pressure when raising/lowering the motor. Where does your transom flex when you are raising/lowering your motor? Are you running any electrical up front for a trolling motor?

Can you post any pictures/descriptions of how you ran the electrical, what battery you went with and it's setup? Great job so far. Looks very clean.

Very creative idea. Thanks for posting. I, too, am tired of chasing my drinks or ending up with empties due to spillage.