Hey that sounds great I just might take you up on that. We are going to be in kaufman most of the time but will have to go to Sachse to visit some familly how far are you from there.
Thank you both for checking out my project. I checked out that site and apparently the guy before me just made up the HIN for this boat the one on the card is only 7 numbers and its supposed to be 12 but oh well. Iv been checking around the web and haven't found one just like it yet but if...
I recently picked this boat up for free. Can anyone help me out as to the make of it. The reg says it a 1965 but not what it is. My plans are to use a jetski motor and build a jet boat. Hopefully it'll all work out. now gotta find a jetski.
nice looking boat. i have the same boat im building. i have a 1969 evinrude 25 hp and everyone has told me that a 25 on this boat will go pretty fast something like 30 to 35 mph. check out my build
https://www.tinboats.net/forum/viewtopic.php?f=21&t=18642
Great job so far it's looking good wish I had thought of that to get all the paint off mine. Well all I can say is it's a good thing you didn't go with the wire wheel idea cause it takes for freaking ever, I'm still not done with mine. And you cant go very long with it cause the grinder gets...
well there isnt a fuel filter on this motor unless you mean the little screen in the tank and i just replaced the float and the little pin under the float and the old one didnt have the clip on it but the new one came with one so it put it on not sure if that could cause this or not but also ill...
Havent posed in a while but i have done some work on the motor i replaced the points and condencers cleaned the fuel pump and checked all lines and did a little to the carb. but its still not running right. can anyone please watch this video and tell me what it could be...
Ok i really need some help!! I just pulled the four bolts holding up the lower unit on my 57 gale 5hp to check everything out and well it comes down bout an inch and wont drop anymore also a spring and a black round thing fell out how do i get it out the rest of the way and where do these parts...
WOW!!! Check out this great find i just got about thirty mins ago. I do computer repair a bit so I was working on this ladies computer and she took me to the garage to get a kitten for my girlfriend and lieing in the corner was this vintage outboard. so i asked about it and she said "What that...
Well today I ordered the flywheel a stingray hydrafoil a carb rebuild kit and a remote throttle control oh and the owners manual for my motor now gotta order the ignition parts and hopefully the thing will be running only bad part is everything is being shipped standard USPS and will prob take...
Yeah i think now im gonna have to do some extinsive work to get it off now cause iv screwed it up worse now but today i realized i have that tool in my box. WOW was i mad but things are ok now. i was worried cause i looked on the evinrude site and the fly wheel is a part that is NOT AVALIBLE...
The one in the first pic is just a scratch and the other is a few really dents from something but i dont think any of it is all the way through there was some crappy bondo on it and is why i didnt notice it before.
once i got over that issue, which was supposed to be just changing the points, i started onto something else. The long gruling prosses of grinding this thing down. and man i tell you no matter what it is you use to do this it will deffinitly wear your a** out. I keep getting tired off one spot...
Well started doin some work yesterday and it was off to a bad start. this dosent lok good at all. anyone have any idea how to get this d*** thing off. man i was mad. wanted to take the sledge hammer to it but i took a deep breath and steped away.