Recent content by shane.b.stanley

The actually arbor or whatever the main piece is called was about 15 dollars, and the actual hole saw ran was about 30 dollars. Quite expensive but it turned out great! I am sure you can shop around and find a different brand for a lot cheaper!

I just installed two sony speakers into my 14' Klamath this past week. The speakers i have required a 5" hole. I used a Milwaukee hole saw and it worked out great!

Thank you! (:

No the boat is light enough to just pull up on the trailer, it practically slides across the boards when wet nicely.

I have a Coleman crawdad, when I bought the trailer it had rollers set up for an aluminum boat. I bought galvanized corner brackets and mounted them to the trailer and removed the rollers. Then added 3 board along the trailer mounted to the brackets. Of course I carpeted the boards. In my...

Thanks for the input! I shall take a look at options!

Well I am not exactly sure as to what I want/need. What I need involves running light for the bow and stern, and a bilge pump. I figure these should be wired to a switch panel. Other things I will install are a fish finder, trolling motor, and a stereo with 2 speakers. I have a 14ft Klamath...

So I have gotten the motor to idle like it is supposed to, I adjusted the idle mixture screw on the carb. I do not have an owners manual (probably should grab one) thanks everyone for your help!

So if it so happens to be an air leak, how would I test for an air leak?

Here are the spark plugs I took out. So now as to adjusting the low speed, where do I look to adjust the low speed?

I do believe the dot is where you are supposed to shift and that is also where it should be able to idle. Took it out today, played around with the very end of the tiller, did notice it slightly move the throttle cable when it is all the way out, (as I turn one way the end of the tiller goes...

Well based on the receipt I was given after the motor was worked on, it said they disassembled the carb and flushed it. I believe they cleaned the Jets and what not by doing so. Previous owner said that he had the carb rebuilt this year. I believe the main problem is the carb due to the motor...

Well I just recently bought a 14' Klamath Deluxe S last week. I was able to take it for a few test drives before purchasing the boat and motor. The first time didn't go as planned because the engine didn't want to idle at all. The owner had the carb flushed and then I was able to take her out...