Search results

Sorry man it was still on the 1st page so I thought it was kind of recent, I noticed the date after I posted.

Would you consider shipping it?

I am trying to figure out the best way to put the foam in the floor between the ribs of my bass tracker. My question is how close do you guys cut the foam to fit. Lets say the shallowest part of the V (closest to the side) is an inch and a half, do you just run an inch and a half thick piece of...

It haf come out of the track so put it back in it looks like I may hace messed up the cam a little but it is staying in place right now as I shift through the gears. And everything is working right

It will move in one direction to open the throttle. I have to push the cam follower back into place by hand to get the motor to throttle down. I just found by looking online that it is a morse control. I cant find a parts diagram for it yet. But thanks for the help it seems to be a control box...

Could it be that the cam is broken? I cant find a model number or name anywhere on the box so I cant find any diagrams or parts

The cablr seems to work fine. The control just doesnt pull the cable back when you throttle down. If you do it manually it works

I dont know anything about these control boxes. It looks like the silver nob should pull the black piece back but it isnt attached in any way. I cant tell if a piece broke off or if it is not on track or what. Any help would be really appreciated

My problem is when I give the boat gas and then pull the throttle back it doesn't throttle down. I thought it might be a broken control cable but I think I have tracked it back to the control box. It looks like the control box will push the cable out but will not pull it back in so the motor...

I had hoped it was just the screw missing in this picture but it wasnt.

Guys I have learned tons from this board and I always appreciate your help, I have another question for you. My Throttle is kind of sticking on my motor, If I give it a lot of throttle it will not throttle back down. My question is this, should the motor automatically push the throttle back...

After that its pretty easy you have six screws that mount the gearcase and three that put top cover back on. Reconnect the wires and screw it back together.20140611_135111.jpg

Before you rewire the controlls etc make sure you put the gear case over the gear or u will have to re do the wire connections. Dont ask me how I know.20140621_102304.jpg20140621_102307.jpg

Once you get that done slide the sleeve up snug and tighten the allan wrench on the top of the gear and the allen wrench on the collar below the outer to keep it in place.

Now put the outer over the sleeve and make sure you put the washer with the ball bearings on before you screw the gear back on top of the shaft. 20140621_093703.jpg Then run your wires through the gear and screw it to the top of the shaft. Thread locker again 1403425831072.jpg This is what I...

Make sure you put the 2 collars that go on the shaft under the outer sleeve next.20140621_093649.jpg

Ok then run the wires through the new shaft from the lower. Time to screw the new shaft into the lower. 20140621_093231.jpgI got the thread started and then used some of the red thread locker (mind went blank).I used my hands to get it pretty tiggt then put the pipe wrench on it too snug it up