Search results

I need to make a console for my 14' tiller to house fuse panel, bus, switches, etc. and I was considering aluminum. Is there any reason it couldn't be made out of .060 aluminum stock as long as it was grounded?

I need to make a console for my 14' tiller to house fuse panel, bus, switches, etc. and I was considering aluminum. Is there any reason it couldn't be made out of .060 aluminum stock as long as it was grounded?

Started to do a DC install, pulled the deck and the bottoms of the plywood were just laying on wet foam. Some much worse than others, but all of it is wet to some degree. Mercifully, most of the marine plywood(at least that's what the label says) is fine. A lot of recent surface mold, and...

I have a very spartan Alumacraft v-14 and am looking to set up a basic DC system: nav lights, anchor light, fish finder, and some night fishing lights. There isn't an obvious spot to place the setup. Battery, main switch, fuse block and switch panel. There are a couple storage pods with...

I am running a 14' V boat with a Yamaha F25 electric start. I bought an interstate deep cycle when I bought the motor last year and was using that as the starter battery, but have since read that the charging system in the motor can ruin a deep cycle battery. Is this the case across the board...

I have an Alumacraft V-14 hull rated for 20 hp, with a 20" transom. I am planning on installing a Yamaha F25 with power t/t, it is about 143 lbs, I think. Is this going to be too much weight for the stern? I see that the F20, (what the hull is rated for), is not much less weight, maybe a few...