TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
1976 Lund C-12
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Gibson" data-source="post: 328229" data-attributes="member: 9026"><p>After that, it was carpet the floor, install the floor, and construct the storage between the rear bench and stern using the same aluminum tubing as noted above for the floor. I made 1 hatch for access. I decided at the last minute to scrap the 2-hatch design since one right behind the swivel seat would be a pain to get to while seated. You'll see I notched the hatch to accommodate for the outboard clamps for opening and closing. Gotta put a hatch pull or handle on it yet. Nothing major.</p><p></p><p>Note: Attaching the floor, bench seats, and rear storage, I used ALL stainless 1-1/2" steel self-tapping pan head screws.</p></blockquote><p></p>
[QUOTE="Gibson, post: 328229, member: 9026"] After that, it was carpet the floor, install the floor, and construct the storage between the rear bench and stern using the same aluminum tubing as noted above for the floor. I made 1 hatch for access. I decided at the last minute to scrap the 2-hatch design since one right behind the swivel seat would be a pain to get to while seated. You'll see I notched the hatch to accommodate for the outboard clamps for opening and closing. Gotta put a hatch pull or handle on it yet. Nothing major. Note: Attaching the floor, bench seats, and rear storage, I used ALL stainless 1-1/2" steel self-tapping pan head screws. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
1976 Lund C-12
Top