TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
2003 Starcraft Starfire conversion
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="harrywbrown" data-source="post: 370882" data-attributes="member: 15464"><p>Another question: the former plywood deck was laid on top of foam blown in on the port and starboard sides with no fasteners used along the deck edge where it meets the interior hull wall (fasteners were used further in of course). I want to lay the cedar deck boards lengthwise across lateral aluminum angle bulkheads. The question is how to fasten the end of the bulkheads to the hull wall given there is only foam below. I was thinking of fastening the end of the aluminum angle bulkheads to aluminum L brackets that are riveted to the interior hull wall. My concern is driving a rivet into the side of the hull. Any concerns or suggestions?</p><p></p><p>[ATTACH=full]69537[/ATTACH]</p></blockquote><p></p>
[QUOTE="harrywbrown, post: 370882, member: 15464"] Another question: the former plywood deck was laid on top of foam blown in on the port and starboard sides with no fasteners used along the deck edge where it meets the interior hull wall (fasteners were used further in of course). I want to lay the cedar deck boards lengthwise across lateral aluminum angle bulkheads. The question is how to fasten the end of the bulkheads to the hull wall given there is only foam below. I was thinking of fastening the end of the aluminum angle bulkheads to aluminum L brackets that are riveted to the interior hull wall. My concern is driving a rivet into the side of the hull. Any concerns or suggestions? [ATTACH type="full" alt="bulkhead attachment 2.jpg"]69537._xfImport[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
2003 Starcraft Starfire conversion
Top