TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Benjineer's Lund S-16 Mod
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="benjineer" data-source="post: 204147" data-attributes="member: 3833"><p>Got my console built, flotation in, and the floor down. Well, I'm not completely done with the floor. It's not behaving right in one of the front corners. I let the sheet be bigger than the space I had for a flat floor. I intended for it to just float up the sides a little in the front corners otherwise I'd have a gap for stuff to get under the floor. The sheet I bought was thicker than my original plan, and it didn't bend so easily, and I also didn't get it centered. I may have to cut some off. Not sure because I ran out of rivets and didn't finish. I sure don't want to pull it back up and start over.</p><p></p><p>[ATTACH=full]24643[/ATTACH]</p><p>[ATTACH=full]24644[/ATTACH]</p><p>[ATTACH=full]24645[/ATTACH]</p></blockquote><p></p>
[QUOTE="benjineer, post: 204147, member: 3833"] Got my console built, flotation in, and the floor down. Well, I'm not completely done with the floor. It's not behaving right in one of the front corners. I let the sheet be bigger than the space I had for a flat floor. I intended for it to just float up the sides a little in the front corners otherwise I'd have a gap for stuff to get under the floor. The sheet I bought was thicker than my original plan, and it didn't bend so easily, and I also didn't get it centered. I may have to cut some off. Not sure because I ran out of rivets and didn't finish. I sure don't want to pull it back up and start over. [ATTACH type="full" alt="IMG00146-20110521-1243.jpg"]24643._xfImport[/ATTACH] [ATTACH type="full" alt="IMG00144-20110521-1108.jpg"]24644._xfImport[/ATTACH] [ATTACH type="full" alt="IMG00145-20110521-1108.jpg"]24645._xfImport[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Benjineer's Lund S-16 Mod
Top