TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Electrical
Can anyone make me an electrical diagram?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="linehand" data-source="post: 192819" data-attributes="member: 5200"><p>Here is a simple scematic. Just ignore the instrumentation. after the switches to your components.</p><p>As far as the motor circuit just use the key as a momentary switch to close the starter relay. then the starter motor on load side of relay. You can inline fuse the control voltage side "key side" of relay. but keep a spare fuse on hand tape it to something under motor cover. Wire size depends on load, add up current on the circuit and size accordingly. Use fine stranded copper and dielectric grease at all connections. Any splices made should be soldered and heat shrinked instead of butt spliced.</p></blockquote><p></p>
[QUOTE="linehand, post: 192819, member: 5200"] Here is a simple scematic. Just ignore the instrumentation. after the switches to your components. As far as the motor circuit just use the key as a momentary switch to close the starter relay. then the starter motor on load side of relay. You can inline fuse the control voltage side "key side" of relay. but keep a spare fuse on hand tape it to something under motor cover. Wire size depends on load, add up current on the circuit and size accordingly. Use fine stranded copper and dielectric grease at all connections. Any splices made should be soldered and heat shrinked instead of butt spliced. [/QUOTE]
Verification
Post reply
Forums
Boats
Electrical
Can anyone make me an electrical diagram?
Top