TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Closing/replacing drain hole
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="JoshKeller" data-source="post: 368962" data-attributes="member: 9811"><p>i'd see if your welder could cut the entire chine/drain plug out about 10 - 12" in front of where the drain is and from next chine to next chine on the sides, and lay a piece of heavy aluminum, .125 or so, over it to form the v. get rid of the chine, get rid of the drain, and beef up the lowest point of the hull a little bit all at the same time.</p></blockquote><p></p>
[QUOTE="JoshKeller, post: 368962, member: 9811"] i'd see if your welder could cut the entire chine/drain plug out about 10 - 12" in front of where the drain is and from next chine to next chine on the sides, and lay a piece of heavy aluminum, .125 or so, over it to form the v. get rid of the chine, get rid of the drain, and beef up the lowest point of the hull a little bit all at the same time. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Closing/replacing drain hole
Top