TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Cutting or bending aluminum sheet
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="overboard" data-source="post: 404024" data-attributes="member: 6547"><p>I cut almost all my aluminum with a carbide blade on either a circular saw or a table saw. MAKE SURE to wear a LS shirt and safety glasses. I clamped a guide on when I used the circular saw so I would get a straight cut. If it isn't a straight cut then you may have to do without the guide.</p><p>Cut it from the backside so the curved edge isn't a problem.</p></blockquote><p></p>
[QUOTE="overboard, post: 404024, member: 6547"] I cut almost all my aluminum with a carbide blade on either a circular saw or a table saw. MAKE SURE to wear a LS shirt and safety glasses. I clamped a guide on when I used the circular saw so I would get a straight cut. If it isn't a straight cut then you may have to do without the guide. Cut it from the backside so the curved edge isn't a problem. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Cutting or bending aluminum sheet
Top