TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
Jet boat Project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="River Rider" data-source="post: 239807" data-attributes="member: 2087"><p>Got the motor more or less put back together. I left some of the cover shrouds off until I get it hung on the boat. I want to be able to run and and check for any possible leaks before I seal her all up. Wasn't too bad of a job, but can't say it was a success until I get her purring. I couldn't help but see if it would turn over so I do know all of that sounds good so far. Tonight I will get some of the garage cleaned up so I can back the boat back in and get the floor hammered out. Hope to have it done by this evening, then that will give me a little time Sunday morning to work on putting the controls and figure the wiring.</p></blockquote><p></p>
[QUOTE="River Rider, post: 239807, member: 2087"] Got the motor more or less put back together. I left some of the cover shrouds off until I get it hung on the boat. I want to be able to run and and check for any possible leaks before I seal her all up. Wasn't too bad of a job, but can't say it was a success until I get her purring. I couldn't help but see if it would turn over so I do know all of that sounds good so far. Tonight I will get some of the garage cleaned up so I can back the boat back in and get the floor hammered out. Hope to have it done by this evening, then that will give me a little time Sunday morning to work on putting the controls and figure the wiring. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
Jet boat Project
Top