TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Lowe 1648MV makeover (near complete)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bamabill" data-source="post: 387368" data-attributes="member: 15102"><p>Tim I used 3/16" throughout. Just make sure you get the proper grip range for the material you'll be joining. Don't know if you can see in the pics, but I only put two rivets on top at each end where the angle contacted the rib. I also added two screws thru the angle into the side of the ribs.</p></blockquote><p></p>
[QUOTE="bamabill, post: 387368, member: 15102"] Tim I used 3/16" throughout. Just make sure you get the proper grip range for the material you'll be joining. Don't know if you can see in the pics, but I only put two rivets on top at each end where the angle contacted the rib. I also added two screws thru the angle into the side of the ribs. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Lowe 1648MV makeover (near complete)
Top