TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
masterbaiters 14 foot build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="masterbaiter" data-source="post: 350857" data-attributes="member: 13367"><p>thanks for the tip rscottp 8) </p><p>i decided on removing the center bench seat to make room for a place for my kids to roam while they get bored and a rod locker.The seat came out in a breeze and the foam under the seat was loaded with mouse holes and all sorts of stuff stuffed up in there. i just wanted a basic idea of what the floor and decks would look like so i cut the 2x3's to measure and attached them to themselves using ss screws.I didnt cut the lower supports yet because i just wanted to see if i was happy with the layout.The transom on the boat had a hole drilled through the top from the previous owner and over the winter it developed a crack through the top of the aluminum where your motor would mount so i went to harbor freight and purchased some alumnaweld.I have never used this stuff and its a total pain in the *** to work with.My welds look like a 4 year old did them but they seem real solid and i just have to grind them down and repaint.</p></blockquote><p></p>
[QUOTE="masterbaiter, post: 350857, member: 13367"] thanks for the tip rscottp 8) i decided on removing the center bench seat to make room for a place for my kids to roam while they get bored and a rod locker.The seat came out in a breeze and the foam under the seat was loaded with mouse holes and all sorts of stuff stuffed up in there. i just wanted a basic idea of what the floor and decks would look like so i cut the 2x3's to measure and attached them to themselves using ss screws.I didnt cut the lower supports yet because i just wanted to see if i was happy with the layout.The transom on the boat had a hole drilled through the top from the previous owner and over the winter it developed a crack through the top of the aluminum where your motor would mount so i went to harbor freight and purchased some alumnaweld.I have never used this stuff and its a total pain in the *** to work with.My welds look like a 4 year old did them but they seem real solid and i just have to grind them down and repaint. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
masterbaiters 14 foot build
Top