TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Mounting to Jon boat seats
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="the fisherman guy" data-source="post: 347716" data-attributes="member: 13667"><p>Thanks Rickybobby, you raise a good point about rigidity factor - one which I didn't think of.</p><p></p><p>I built a dual rocket launcher from parts kicking around in the shop, just for transport of rods during transport and net while fishing. This will be mounted to the rear bench seat. That would be simple enough to install, but the decking would be a different story. The entire rear of the boat seating area would need to be removed, and re-installed for non-structural integrity purposes. I am leaning more toward toggle bolts or self tapping sheet metal screws - but I doubt the sheet metal screws would hold very well over time. </p><p></p><p>Epoxy? PL? JB Weld??? What has everyone else done?</p></blockquote><p></p>
[QUOTE="the fisherman guy, post: 347716, member: 13667"] Thanks Rickybobby, you raise a good point about rigidity factor - one which I didn't think of. I built a dual rocket launcher from parts kicking around in the shop, just for transport of rods during transport and net while fishing. This will be mounted to the rear bench seat. That would be simple enough to install, but the decking would be a different story. The entire rear of the boat seating area would need to be removed, and re-installed for non-structural integrity purposes. I am leaning more toward toggle bolts or self tapping sheet metal screws - but I doubt the sheet metal screws would hold very well over time. Epoxy? PL? JB Weld??? What has everyone else done? [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Mounting to Jon boat seats
Top