TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
My 14' Jon Mods So Far, But Looking For Help With The Rest
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="F239141" data-source="post: 244402" data-attributes="member: 7679"><p>well there was a leak between the power head and intake ( I know thats probably not the technical name for the parts) I sealed it up, also the "plug" as the parts book calls the needle in the bottom of the carb is a fuel inlet needle, and had to be opened some. Of course replaced the flywheel key.</p><p></p><p>Im not sure if its going to run "right" yet I havent had time to tune the carb</p><p></p><p>Either way its a major weight off my back that it will atleast run again, I really hope it runs good. Im sure between the points, condencer, fuel pump that Don replaced, and the water pump, carb rebuild, leaf valves, spark plugs and then the little things like the recoil and keyway it will run good, unless its a compression issue...... then I will have to figure out if i want to rebuild or trade up for a newer one.</p></blockquote><p></p>
[QUOTE="F239141, post: 244402, member: 7679"] well there was a leak between the power head and intake ( I know thats probably not the technical name for the parts) I sealed it up, also the "plug" as the parts book calls the needle in the bottom of the carb is a fuel inlet needle, and had to be opened some. Of course replaced the flywheel key. Im not sure if its going to run "right" yet I havent had time to tune the carb Either way its a major weight off my back that it will atleast run again, I really hope it runs good. Im sure between the points, condencer, fuel pump that Don replaced, and the water pump, carb rebuild, leaf valves, spark plugs and then the little things like the recoil and keyway it will run good, unless its a compression issue...... then I will have to figure out if i want to rebuild or trade up for a newer one. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
My 14' Jon Mods So Far, But Looking For Help With The Rest
Top