TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
My First Boat and Build, HELP!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="xxxKYDxxx" data-source="post: 362525" data-attributes="member: 14882"><p>Yeah I think my plan is going to be to Use almost all of them. I'll probably go on the inside with the 5200 in all the cracks, crevices, seams, etc and then go over that once its cured with a couple shots of FlexSeal. And then on the outside I'll go over the rivets and seams with GLUVIT. I dont know of any other ways to seal it off. And just to be on the safe side i'll install a bilge pump hooked up to a float switch.</p></blockquote><p></p>
[QUOTE="xxxKYDxxx, post: 362525, member: 14882"] Yeah I think my plan is going to be to Use almost all of them. I'll probably go on the inside with the 5200 in all the cracks, crevices, seams, etc and then go over that once its cured with a couple shots of FlexSeal. And then on the outside I'll go over the rivets and seams with GLUVIT. I dont know of any other ways to seal it off. And just to be on the safe side i'll install a bilge pump hooked up to a float switch. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
My First Boat and Build, HELP!
Top