TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Old Guy Comfort Boat
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="gah319" data-source="post: 337014" data-attributes="member: 13154"><p>So over the last week I have gotten the rear bench frame work built. Making the measurements and then constructing in the basement. First made the front cross member and then the second. Placed both in the boat and measured for the distance between the two. Connected the two end connectors to the front section. Placed both back in the boat and riveted the second section section when I was happy with the fit. Take it all back in and finish. The plywood in the pictures are just for the mockup. The storage area will have a opening of 14x16. I think I will make the lid so that it opens from the seat to the side instead of front to back. The area under the seat I plan on filling with flotation. Full set of the pictures can be seen at the link below.</p></blockquote><p></p>
[QUOTE="gah319, post: 337014, member: 13154"] So over the last week I have gotten the rear bench frame work built. Making the measurements and then constructing in the basement. First made the front cross member and then the second. Placed both in the boat and measured for the distance between the two. Connected the two end connectors to the front section. Placed both back in the boat and riveted the second section section when I was happy with the fit. Take it all back in and finish. The plywood in the pictures are just for the mockup. The storage area will have a opening of 14x16. I think I will make the lid so that it opens from the seat to the side instead of front to back. The area under the seat I plan on filling with flotation. Full set of the pictures can be seen at the link below. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Old Guy Comfort Boat
Top