TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Ouachita 16DSV mod starting...update 4/30/13
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Ringo Steele" data-source="post: 301556" data-attributes="member: 6694"><p>Hi folks,</p><p>Well, I finally got up the nerve to start cutting into my Ouachita 16 semi-vee, after a couple of years of debating a mod. </p><p></p><p>The first stage is modifying the center of the three bench seats to have a walk-through design. </p><p></p><p>Following that, I will be installing a flat floor from the rear bench to the front bench. </p><p></p><p>Planning a casting platform from the front bench to the front triangle seat at seat height. </p><p></p><p>Possibly followed by some storage built in between the center and front benches on each side. </p><p></p><p>Here's a few pictures of the first stage (that I am hoping to be able to complete tomorrow!). Notice the seat foam...the top end was on the port side and was a little too close to a brush fire many years ago. I found two small puddles of melted foam in the bottom when I opened up the bench seat.</p></blockquote><p></p>
[QUOTE="Ringo Steele, post: 301556, member: 6694"] Hi folks, Well, I finally got up the nerve to start cutting into my Ouachita 16 semi-vee, after a couple of years of debating a mod. The first stage is modifying the center of the three bench seats to have a walk-through design. Following that, I will be installing a flat floor from the rear bench to the front bench. Planning a casting platform from the front bench to the front triangle seat at seat height. Possibly followed by some storage built in between the center and front benches on each side. Here's a few pictures of the first stage (that I am hoping to be able to complete tomorrow!). Notice the seat foam...the top end was on the port side and was a little too close to a brush fire many years ago. I found two small puddles of melted foam in the bottom when I opened up the bench seat. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Ouachita 16DSV mod starting...update 4/30/13
Top