TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Electrical
Replacing Motorguide Shaft
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="warefishin" data-source="post: 355516" data-attributes="member: 13325"><p>Then I removed the 6 screws that are under the hood to relese the steering cable. I cut the wires because I knew I would have 10 inches of extra wire because of the shorter shaft. if I had it to do over again I would have just squeezed the factory connections with pliers so I wouldnt have to worry about coming up short with a couple of inches of wire from the harness.</p></blockquote><p></p>
[QUOTE="warefishin, post: 355516, member: 13325"] Then I removed the 6 screws that are under the hood to relese the steering cable. I cut the wires because I knew I would have 10 inches of extra wire because of the shorter shaft. if I had it to do over again I would have just squeezed the factory connections with pliers so I wouldnt have to worry about coming up short with a couple of inches of wire from the harness. [/QUOTE]
Verification
Post reply
Forums
Boats
Electrical
Replacing Motorguide Shaft
Top