TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
RPM Readings and Prop Selection
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bcbouy" data-source="post: 464326" data-attributes="member: 4563"><p>i put a bad chip and slight warp to my 13.5x15 and the prop wizard recommended a 13.25x19p as an alternative.seems a little bit high for pitch,but i'm going to give it a go anyway.i would actually like to lose a little bottom end holeshot so i can troll a little slower.when my evinrude touch troll control is running at 600 rpm it's a little bit too much vibration.my engine is a 40 etec.</p></blockquote><p></p>
[QUOTE="bcbouy, post: 464326, member: 4563"] i put a bad chip and slight warp to my 13.5x15 and the prop wizard recommended a 13.25x19p as an alternative.seems a little bit high for pitch,but i'm going to give it a go anyway.i would actually like to lose a little bottom end holeshot so i can troll a little slower.when my evinrude touch troll control is running at 600 rpm it's a little bit too much vibration.my engine is a 40 etec. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
RPM Readings and Prop Selection
Top