TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Trying to replace gasket between powerhead and shaft housing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Pappy" data-source="post: 407475" data-attributes="member: 3278"><p>What you were looking at on the bolts is a bonded on lock patch......from the factory. The patch typically comes off with one or two cycles. </p><p>If you have a flywheel puller and a hoist you can apply some pull on the powerhead. Make sure you have a good solid closing hook in case it comes loose and flies up! Ask me how I know........</p></blockquote><p></p>
[QUOTE="Pappy, post: 407475, member: 3278"] What you were looking at on the bolts is a bonded on lock patch......from the factory. The patch typically comes off with one or two cycles. If you have a flywheel puller and a hoist you can apply some pull on the powerhead. Make sure you have a good solid closing hook in case it comes loose and flies up! Ask me how I know........ [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Trying to replace gasket between powerhead and shaft housing
Top