TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Vance Manufacturing Jack Plates
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="wmk0002" data-source="post: 467585" data-attributes="member: 13975"><p>As an FYI to all, this unit does not fit well with a 25/30 Yamaha 3 cylinder. I'm now glad I held off on installing until I got a bigger motor because I don't think it would have worked. On top of that I got a Panther TnT unit with the motor and it has a BIA transom pattern which is larger than this jack plates transom side fastener pattern. So if I would have installed it, then to add the Panther unit I would have had to drill 4 new holes.</p><p></p><p>I bet this unit would still be perfect for a most 25hp outboards, but be advised to check before you buy. Vance has a model JPL6000 which is a manual model rated to 150hp which is a few pounds heavier but has a standard BIA pattern on the transom side and can be purchased with a board on the motor side to accommodate a clamp on motor or one without the BIA bolt pattern.</p></blockquote><p></p>
[QUOTE="wmk0002, post: 467585, member: 13975"] As an FYI to all, this unit does not fit well with a 25/30 Yamaha 3 cylinder. I'm now glad I held off on installing until I got a bigger motor because I don't think it would have worked. On top of that I got a Panther TnT unit with the motor and it has a BIA transom pattern which is larger than this jack plates transom side fastener pattern. So if I would have installed it, then to add the Panther unit I would have had to drill 4 new holes. I bet this unit would still be perfect for a most 25hp outboards, but be advised to check before you buy. Vance has a model JPL6000 which is a manual model rated to 150hp which is a few pounds heavier but has a standard BIA pattern on the transom side and can be purchased with a board on the motor side to accommodate a clamp on motor or one without the BIA bolt pattern. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Vance Manufacturing Jack Plates
Top