CMC BA 130 on Alumacraft 1648

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

lgpjr49

Well-known member
Joined
Apr 16, 2014
Messages
182
Reaction score
0
Location
Macon, GA
Has anyone used a CMC BA 130 on an Alumacraft 1648? The boat is riveted, and I wondered how it will hold up with the transom after the set back. The motor is a Tohatsu 30hp 4 stroke. Any advice, experience or feedback would be appreciated.

Sent from my SM-G930V using Tapatalk
 
should be fine, but rivets don't stay tight forever. Might have to buck one or two of them once in a while.
 
I had a 2008 Crappie Jon with a jack plate, t@t, 20 hp for several years. That's a riveted boat and never had an issue with rivets.
 

Latest posts

Top