moloch16
Well-known member
My new Alweld boat came with a wonderful factory installed transducer mount. Only issue is it isn't wide enough for the standard Lowarnce bracket. Looking for ideas on how to mount the transducer.
Options I've considered is adding material to make the mount point wider, but that might create a rooster tail since it will extend pass the mount point.
Or drilling new holes next to the exist screw holes but closer in. Probably can't get them as nice as the factory ones
Any other options / ideas?
Options I've considered is adding material to make the mount point wider, but that might create a rooster tail since it will extend pass the mount point.
Or drilling new holes next to the exist screw holes but closer in. Probably can't get them as nice as the factory ones
Any other options / ideas?