Tilt and trim ?

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
If it's like my mid 80's version I had to run it up and down many times to get the air out. It was foamy so I did it again the next day to get the rest out.
 
Pappy said:
Sure.....with the trim all the way to the top you fill until the fluid runs out the hole you are filling from.
Can never fully empty those systems so there is not a good exact answer.
Ok thanks pappy it is empty I am taking it apart the cyl was leaking at the top
 
Pappy said:
Chances are the valve body and reservoir under the pump still has plenty of fluid in it. Hopefully you just disconnected the ram at the top and unscrewed the cap to repair instead of pulling the whole unit. Lots easier.
Nope the hard way lol too it out and put on the bench
 

Latest posts

Top