Good evening everyone. First post and first question. Looking to buy a motor for a flat bottom. The specs say max is 7.5 hp. I don’t like the prices on the new motors so was thinking about going used. My question is how hard are they to work on with all the information available online. I can find several for $300-$400 and they often state “ran good when put up”.
If I were to stick with a name brand will parts be available to get it going good again? The motors in my area will predominantly all have been used for fresh water as we are 5 hours from the coast. Also anything specific I should look out for?
Thanks for your input as I try to figure out what to do.
Rex
If I were to stick with a name brand will parts be available to get it going good again? The motors in my area will predominantly all have been used for fresh water as we are 5 hours from the coast. Also anything specific I should look out for?
Thanks for your input as I try to figure out what to do.
Rex