Beautifully simple thank you. Am I replacing the rivets and then hammering them? Or just deforming the existing rivets to expand and so it doesn't leak any more?
I hear what you're saying but I think people underate these small HP motors considering I've used a 2.5hp on a ten foot wooden boat in saltwater I know it's two different environments but if it can handle the sea and travel a moderate speed even with wind then I figured a 3.5 would be ok for the...
Ok I was thinking in lieu of the center bench was a 2x4 spanning the width of the bottom and other 2x4's at a 45 degree angle from the gunnels to the bottom 2x4 and I was thinking of doing 2 that way the outside pressure would push the angled 2x4 down into the horizontal 2x4 spanning the bottom...
Hello all I'm a newbie when it comes to aluminum boats and their repairs and modifications. I have a 12 ft aluminum v hull and I'm looking for helpful info. What's the simplist way of removing the middle bench and putting a flat floor in? not a mini bass boat setup as I like to keep center of...