Billinthedesert

Sonny, I greatly admire your determination, and after four lumbar fusions, I have been down that pain road. Best of luck.

Well this is just great. Electric drill took a dump. Wire brush job is on hold until the wife gets back from Harbor Freight. 70 degree...

FYI, there have been a few drownings in this area recently, so I was reminded of a post that I once added to my Parker boat website when...

This is an excellent thread and it really drives home the point that drownings often will not present as someone in distress. A while...

Time for new floors finally!

I just put the same pink foam board in mine while I’m rebuilding. The ribs in my 16/52 are 2” so I used 2” foam board and epoxy treated...

I picked up an Alumacraft 1542 in late January and only had a week before our first spring bass trip so needed a quick temporary floor...

hi all, vacation was amazing, and I'm back at it with the 1236 this weekend. Did alot of this in Zion and bryce canyon while we were...

Alright, made good headway on some framing. got the side-rails all done. Started framing out what will be front deck and storage...

First G/flex application tonight. Sealed the outer hull rivet seams. Took a minute to get adjusted to working with it, but it went on...

Rats. A break in the action. Got crampons for Bryce?

My motivational speaking calendar is booked up for the next several months by trying to motivate my 2.5 year old daughter to eat her dinner.

1998 is a good year for those motors. What's with all the Rustoleum rust primer sprayed on everything??? I'd be using some carb...

And the floors got some shine haha

Got the first coat of paint laid down. It's going to take a while lol. Also, fairly sure this boat is a Marlin.