Recent content by lap202

IN

IN The 14th is my birthday, hoping for some birthday luck. Sent from my SM-G950U using Tapatalk

Any advice on how to repair this. The back of the boat has a crack on the bottom. Kind of ecplains why after an hour theres 4 or 5 inches of water in the boat. Sent from my SM-G950U using Tapatalk

Quick update, interior is almost ready to prime. Just a little more sanding. Have been fitting carpet for the section between the benches. Got back sanded and primed. Sent from my SM-G950U using Tapatalk

IN Sent from my SM-G950U using Tapatalk

Right now its just sitting there. Did a pretty good cut for size. After i paint the inside of the boat it will have some angle brackets on bottom of deck rivetted to the boat and screws through the oar holders into the top. Sent from my SM-G950U using Tapatalk

So if you ignore the date i started this we can pretend theres been progress! Alot has happened since my last post... had a daughter and the boat progress haulted. Today i finally got back at it. Removed the front bench to prepare for the deck, carpeted the deck and got the cup holder...

It will be easy enough with this trolling motor to rotate it. Will then add a foot switch I found that will be between the battery and motor so I can turn it on and off from my pedestal I'll be putting in up front. Sent from my SM-G950U using Tapatalk

So havent left an update in awhile as I havent got much more done on the boat. I got the trailer working by running a ground from 1 side of the hinged trailer to the other. Have been fishing the boat ever since. This last weekend we fished 3 out of it successfully, tho it only topped at 11 and...

I'll have to fiddle around next time I try floating my boat to see how sun light affects visibility. Ultimately I just need to keep my eyes on classifieds for a budget fish finder and possibly gps. Sent from my SM-G950U using Tapatalk

Will be using rubber fittings so metal edges wont be a problem. As I'm on a hard budget I figure using the existing boat instead of running PVC will save me some cash. Will still end up running some PVC in the middle but not much. My girlfriend and son are back from a trip so my progress will...

Trailer is hinged so we will be running wires. For the electronics on the boat I was curious if I could run the wires through the gunwale. I'd have a hole drilled in the back, one drilled in the middle and a hole drilled in the front. These would be for the rear and front navigation lights...

IN Sent from my SM-G950U using Tapatalk

I'm thinking it may be related to the trailer having 2 parts as it has a swivel in the middle for easy launching. -- Today we decided to just toss it on top of a jeep and take it out for a test run. Our first attempt we launched into a stream by a dam that leads to a lake with no other access...

What I noticed on the lights is if it my test light to the ground on the connector while the cable is completely unplugged, I get power through the light. Thinking a bad crimp in the connector. Sent from my SM-G950U using Tapatalk