Recent content by PSG-1

Feel free to join our page: https://www.facebook.com/groups/100628827104136/

Good to hear from you again, mmf! The specs say the 2472 sea ark weighs about 950 lbs, just the dry hull weight. Then you have to account for weight of engine, fuel, battery, persons on board, gear, additional decking/modifications. A boat that size, especially with the wide beam, would be a...

Thanks! Sometimes you just gotta improvise. 8)

Repairing a boat for a customer. Showing how to leak test, and a few tips on patching corrosion. https://www.youtube.com/watch?v=ERXtSbp5Kh4

Blewett Falls Spillway, Pee Dee River, Rockingham, NC. https://www.youtube.com/watch?v=EtcXmmcrkHE

These are the remains of fish traps built by the PeeDee and Cheraw Indians thousands of years ago, along the PeeDee River, just downstream of US74 at Rockingham, NC. Enjoy!! 8) 8) https://www.youtube.com/watch?v=n1O3HOqtcLc

I fixed my porpoising problem by making a ride plate that extends all the way back to the end of the steering nozzle, and then using a set of shims at the rear. Made the shims from some 1/8" X 1" flat aluminum stock, cut to 1" length, and with a 3/8" hole in the center for the rear bolts to pass...

Yeah, the water temp is still about 63 degrees. But these warm days will likely draw fish into the marsh. They seek out the warmth of the pluff mud during incoming tides, as it has been warmed by the sun during the period of low tide. Your best fishing is going to be an hour after low until the...

Nice!! 8) The engine and the pump is the hardest part. Once you get those components installed, it's smooth sailing from there.

You can probably get an aftermarket +5 degree nozzle, or a +5 degree pump wedge that fits between the stator and the thrust nozzle (like Capt1972 mentioned) This will make a difference.

Yep, I know all about cutting a tank to make it fit the boat. :mrgreen: This is what I had to do with my jet boat's tanks, so they would fit the profile of the gunwale:

Those top loader grates are OK if you only run on open water, where there is chop (and no debris). On choppy water, they perform as advertised, feeding more water to the pump and minimizing acceleration slip. But on inland rivers, bays, back creeks, and other shallow areas, or in areas where...

This is just an educated guess, but I think the voids caused by the rivets not letting the hydroturf adhere flat to the surface could lead to bubbling in those spots. Then again, I might be wrong about that.

I just used the little ones that are on the plastic sticks, and zip-tied them to the stern light:

Yeah, like I said, I am SO glad I decided to go ahead and reinforce the area around the pump with all that plate. That probably saved me a busted steering nozzle, thrust nozzle, reverse gate, and the steering and reverse cables. The plates worked so well, that the boat itself never touched the...