Recent content by Vader809

I was looking for a used outboard 9.9 hp. People are asking for just shy of new one. A 1990 two stroke Johnson, asking 1,800.00!? I tried to get a price on a new Tohatsu online and they wanted your entire personal history, so they can blow up your phone. Might not be a good time for getting...

No, they came out with BT I pilot link about a year and a half later.

Thanks! That's a great idea. I used to work in a steel mill and I have a few small pieces of steel that just perfect for that.

I have a gen one Terrova 80 and I don't think it's compatible with installing i-pilot link,also have a gen one HB 9si,and gen three 7di. I'm not going into debt just to have a better system. It's nice, but not 5k nice!

That's a good sized boat. Not a quick rebuild. If you're wanting on the water, fix whatever it needs and then move on to other problems. I'd check the flooring and what's under it.

Aluminum. Maybe 1/4"&1/8" screw and bolt holes.

I have some holes that I want to fill, they are above the water line, and I'd like to fill them in because previous owners had many objects attached. I'm wanting to paint the sides, I'm not fond of battle ship gray. Any advice is appreciated.

I find it hard to believe the biggest majority of reviews on Amazon. If I really trusted the third party, I would buy from their stores. However some are pushing the Patreon factor by just letting you see a sped up clip. I purchased a Miller tech 12 volt 33 amp just for my electronics and I am...

I have a Terrova 24 volt and some places are saying that I two 100 amp hour,and others two 65 amp hours. And at roughly $800 each or more, I'm very leery of dropping that kind of money. But I did get a 12 volt 33 amp hour lifepo for my electronics at$249.99 and I consider that a good deal. Some...

You did a great job!

I used1/8" and 1/4" for critical areas. I have 3/4" and 1 1/4" for the same reason. I even use Square tube for more support, especially if I am standing on it. Good luck.

Any dyi boat cover ideas out there?

I would stay away from the big box store bench top model. You want one with sturdy table that will take a fence, because all that comes with those models, is a flimsy and sloppy little plastic fence. You don't want the table to move when putting a bit of pressure on it.

I've read about Nano bubbles in an article about waste water treatment. It does do what the companies says, but the cost is very expensive. There are places that use it and their views are mixed about getting the money approved, due to the fact some of the people feel like it's comming out of...

Thanks. I received injections and seems to work so far.