Search results

Wondering if anyone here has the part numbers for the 5 needle bearings in the gearcase of a 78 evinrude 9.9. I'm looking for the torrington part numbers, not the evinrude numbers. I'm trying to do my research before pulling all the bearings. I want to get replacements at my local bearing house...

As the title says 78 9.9 it has a misfire at wot have only run the motor in a test tank or with earmuffs on so far. Starts good idles fairly smooth. The motor has sat for 20 year or so according to the seller. I've cleaned/rebuilt the carb, adjusted the carb/timing sync. New plugs (correct...

Hey guys need a little more help on this trailer im working on. see post..... https://www.forum.tinboats.net/viewtopic.php?f=49&t=43441 .....for a little history. anyway mid 80's adjustable ez loader. it has the open end slipper style springs. the bushings were wore out so I finally got the...

hey guys, got a question. 76 mirrocraft, ez loader adjustable trailer. the trailer did not fit the boat well enough in my opinion, so It has been lengthened about 2 feet to accommodate it better. I'm at the point of making the bunks and my question is on regard to positioning. If I place them to...

So, my little 14' aluminum has been out in the sun for a while uncovered and I am trying to clean up the paint. Is there any products that can be sprayed on that will clean off the oxidized paint? I have used castrol superclean before but it is a little too strong and tends to damage the...

Its a little tough to see in the photo, but where does this attach? Im thinking maybe one of the engine cover mounts? Or maybe one of the coil pack mounting bolts? its the 85 johnson 15 horse.

to save the time and aggravation of searching, I will just ask. Fixing to repair the transom in my 76 mirrocraft 14ft. looking to do the job well, but not necessarily the absolute best. my plan is to glue 2 pieces of 3/4 BC plywood with titebond III waterproof. I'm wondering about the best thing...

where exactly is the water supposed to exit on an 85 johnson 15 horse? Im not sure if mine is pumping water correctly.

1985 johnson 15, trying to figure out if the carb is supposed to have a removable bushing/seat for the idle/low speed mixture screw or if the seat is machined into the carb casting. One exploded view diagram from a parts site shows no removable seat, but the instructions with the rebuild kit...

1985 johnson 15 horse. replacing water pump, got the sierra 18-3327 kit. 2 questions. first, the small o ring in the kit, where does it go? I have matched up all parts with the existing pump installed except for the small o ring. Maybe the kit fits multiple models and maybe others use the small...

Picked up an 85 johnson 15 horse. in the process of cleaning out the marine grease that someone put on EVERYTHING under the cowl. the motor has been sitting a while and that grease is like tar now. anyhow, what lubricants do you guys suggest using for things like the tiller control gears and...

Hey guy's, new to the site and already have a question. I am doing bearings and seals on a 99 tracker trailstar trailer, and after removing the hubs, I found o rings on the axle shaft behind the grease seal. I am not an expert but haven't come across this on the few trailers I have done. any...