Search results

Thanks. Tested my charger and it wasn't working, even though the lights were on. So I apparently have been just draining the battery. Got a new charger and will see how it works out.

Thanks for your help.

Up until about 2 months ago, I had one battery that started my electric start 15 HP Johnson motor, ran my 55 lb Minn-kota trolling motor and powered my very old Eagle depth finder. Also wired to front and rear lights on my 14 ft 1972 Mirrocraft aluminum boat. Ran this way for a couple or...

I have a 1972 Mirrocraft with a Johnson 15 hp electric start that I have had for 5 -6 years. I took the bench seats out and put in a floor and pedestal seating for 3. Like to keep the floor a little lower. Didn't put in a deck. Battery up front which levels it off very nicely when I am by...

Got mine in the mail yesterday.

IN

No, nothing too big yet. Only had it out once yet and it was a calm day.

Didn't post while working on this, but have finished putting in the floor and pedestal seats. Added bracing to the sides because I took all 3 bench seats out and put rod holders on the them. Sides are very firm. Took it out on the water. worked very well.

IN Sent from my SM-G935T using Tapatalk

Thanks.

While I am asking and about to purchase materials, advice on what adhesive to use to attach carpet to the wood floor. Thanks for your help. Sent from my SM-G935T using Tapatalk

Thanks for the input. How thick of aluminum bracing should I be using? Thanks

Thanks for the advice. I am using 5/8 " plywood. I am planning to put more support under the floor before I finish. Yeah, I understand I lose a lot of side support by taking the 3 seats out. That's why I am looking for some supports. I may end up putting one or two seats back in.

Just starting to put a floor in my boat. Looking for some advice. I have removed all the bench seats and am putting in pedestal seats. Anyone know where I can get same angle braces for the sides? Also, advice on what to use to seal the wood? Thanks

Did you fasten the floor to the boat or is it unattached? Sent from my SM-G935T using Tapatalk

Very nice. I have a early 70s 14 foot Mirrocraft I have just started on. Good ideas here. Sent from my SM-G935T using Tapatalk

I have been following this thread because I have a Mirro Craft that I would like to do something similar with. Do you have the measurements you used to do this? It looks really nice!!!