TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
1967 Starcraft Seafarer - 1986 Evinrude 40hp
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="samuelh1987" data-source="post: 494208" data-attributes="member: 21854"><p>I'm a heavy guy approximately 275. My fishing pals are all above 225. May need the extra umph lol. Started tear down today. Got the floor, styrafoam, and "custom" decking out. Still have a few bits attached like the framing for the deck and bench seat top. I honestly wonder if the floor isn't factory. It's got a support that runs bow to stern down the center line. It looks too good to be a diy job. It was also pop riveted in. Surprisingly the foam wasn't too bad. 1 spot from mice, I'll cut that out replace and reuse it. The pieces were like 8' by 10", and shaped to the floor. Another reason why I wonder about it, It had a big cap on to the bow that has been cut back. Why someone does that is beyond me? Boats 14' and some change X 62'', but sort of flairs inward up at the gunnels.</p></blockquote><p></p>
[QUOTE="samuelh1987, post: 494208, member: 21854"] I'm a heavy guy approximately 275. My fishing pals are all above 225. May need the extra umph lol. Started tear down today. Got the floor, styrafoam, and "custom" decking out. Still have a few bits attached like the framing for the deck and bench seat top. I honestly wonder if the floor isn't factory. It's got a support that runs bow to stern down the center line. It looks too good to be a diy job. It was also pop riveted in. Surprisingly the foam wasn't too bad. 1 spot from mice, I'll cut that out replace and reuse it. The pieces were like 8' by 10", and shaped to the floor. Another reason why I wonder about it, It had a big cap on to the bow that has been cut back. Why someone does that is beyond me? Boats 14' and some change X 62'', but sort of flairs inward up at the gunnels. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
1967 Starcraft Seafarer - 1986 Evinrude 40hp
Top