TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
1974 RHYNCRAFT MAKEOVER
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="BAY BEAGLE" data-source="post: 486330" data-attributes="member: 31457"><p>Jim - never did one from start to finish .... but have done plenty of repair ... enjoying the challenge, and research put into making it happen. GREAT SITE TO REAP THE KNOWLEDGE OF OTHERS!!!</p><p></p><p>Had this bad spot along the top rail line, where a large branch made it's mark. The vote was to weld it, and I agree. One suggestion was to perhaps cut a section out, and rework the rail. I gave that some serious thought, but wanted to try a few tricks.</p><p></p><p>BEFORE:</p><p>[ATTACH=full]110329[/ATTACH]</p><p>[ATTACH=full]110330[/ATTACH]</p><p></p><p>AFTER:</p><p>[ATTACH=full]110331[/ATTACH]</p><p>[ATTACH=full]110332[/ATTACH]</p><p>[ATTACH=full]110333[/ATTACH]</p><p></p><p>Move on to the transome, before I pull out the MIG.</p></blockquote><p></p>
[QUOTE="BAY BEAGLE, post: 486330, member: 31457"] Jim - never did one from start to finish .... but have done plenty of repair ... enjoying the challenge, and research put into making it happen. GREAT SITE TO REAP THE KNOWLEDGE OF OTHERS!!! Had this bad spot along the top rail line, where a large branch made it's mark. The vote was to weld it, and I agree. One suggestion was to perhaps cut a section out, and rework the rail. I gave that some serious thought, but wanted to try a few tricks. BEFORE: [ATTACH type="full" alt="18472.jpeg"]110329._xfImport[/ATTACH] [ATTACH type="full" alt="18468.jpeg"]110330._xfImport[/ATTACH] AFTER: [ATTACH type="full" alt="18553.jpeg"]110331._xfImport[/ATTACH] [ATTACH type="full" alt="18550.jpeg"]110332._xfImport[/ATTACH] [ATTACH type="full" alt="18552.jpeg"]110333._xfImport[/ATTACH] Move on to the transome, before I pull out the MIG. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
1974 RHYNCRAFT MAKEOVER
Top