TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1986 Evinrude 40 Tiller, How to wire fuel primer solenoid
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="samuelh1987" data-source="post: 494143" data-attributes="member: 21854"><p>Picked up a 1986 Evinrude 40 Tiller motor on a project hull. The fuel primer solenoid was wired to a aftermarket switch that was added to the lower right motor cover. It had a momentary switch that the toggle snapped off on the way home due to a hard stop and the motor swinging to the side. How should the primer be wired to be correct? My motor only has the push button start.</p></blockquote><p></p>
[QUOTE="samuelh1987, post: 494143, member: 21854"] Picked up a 1986 Evinrude 40 Tiller motor on a project hull. The fuel primer solenoid was wired to a aftermarket switch that was added to the lower right motor cover. It had a momentary switch that the toggle snapped off on the way home due to a hard stop and the motor swinging to the side. How should the primer be wired to be correct? My motor only has the push button start. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1986 Evinrude 40 Tiller, How to wire fuel primer solenoid
Top