TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Anyone create FRP Board and Polystyrene sandwich for decking.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="fwman1" data-source="post: 493613" data-attributes="member: 31515"><p>I forgot to add, the panel weighs 20.1.lbs</p><p>It is about 12 square feet.</p><p></p><p>I mixed 36 ounces of epoxy for each side lamination. A total of 72 ounces for this deck. There was some extra in each batch, and some that oozed out the laminations. </p><p></p><p>I spread a coat on the foam, then spread a coat on the FRP board. Once I put the FRP board on the foam, I tried to push out as much of the excess as possible. I wanted to ensure that I had a wet joint throughout.</p><p></p><p>Tomorrow I'm working on the center and side supports. I'll be rewiring my boat for the new setup of casting deck,</p><p>new trolling motor, and new fishfinder. Hopefully I'll get it on the water to test out before too long.</p></blockquote><p></p>
[QUOTE="fwman1, post: 493613, member: 31515"] I forgot to add, the panel weighs 20.1.lbs It is about 12 square feet. I mixed 36 ounces of epoxy for each side lamination. A total of 72 ounces for this deck. There was some extra in each batch, and some that oozed out the laminations. I spread a coat on the foam, then spread a coat on the FRP board. Once I put the FRP board on the foam, I tried to push out as much of the excess as possible. I wanted to ensure that I had a wet joint throughout. Tomorrow I'm working on the center and side supports. I'll be rewiring my boat for the new setup of casting deck, new trolling motor, and new fishfinder. Hopefully I'll get it on the water to test out before too long. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Anyone create FRP Board and Polystyrene sandwich for decking.
Top