TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Drilling 3/4" hole in side of boat....Tips/Advice
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Vol423" data-source="post: 492254" data-attributes="member: 6621"><p>A couple of ideas and observations:</p><p></p><p>I use a hole saw to cut through the hull for the through hull. Dozens done and never a problem. Use silicone sealer and stainless hose clamps. Screw the pump to a piece of cutting board (or HDPE), to keep the pump upright and out of the debris. Replacement will be a breeze. If you get vibration, glue the HDPE to the hull with a dollop of silicone sealant.</p></blockquote><p></p>
[QUOTE="Vol423, post: 492254, member: 6621"] A couple of ideas and observations: I use a hole saw to cut through the hull for the through hull. Dozens done and never a problem. Use silicone sealer and stainless hose clamps. Screw the pump to a piece of cutting board (or HDPE), to keep the pump upright and out of the debris. Replacement will be a breeze. If you get vibration, glue the HDPE to the hull with a dollop of silicone sealant. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Drilling 3/4" hole in side of boat....Tips/Advice
Top