TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Homemade Penetrating Fluid - the BEST you can use! DIY too
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="driz" data-source="post: 419718" data-attributes="member: 13373"><p>I use it and it works great. It takes a bit of time though. For better try using your air chisel with a blunted (cut off) tip. You take that rig soak it in the mix and hammer away on the end of the bold or side of the nut . The vibration will get that oil right down in there. A guy showed me that trick on a 2" pin on an old Northcountry back hoe once. Sure works better and is far easier than beating with a BFH.</p></blockquote><p></p>
[QUOTE="driz, post: 419718, member: 13373"] I use it and it works great. It takes a bit of time though. For better try using your air chisel with a blunted (cut off) tip. You take that rig soak it in the mix and hammer away on the end of the bold or side of the nut . The vibration will get that oil right down in there. A guy showed me that trick on a 2" pin on an old Northcountry back hoe once. Sure works better and is far easier than beating with a BFH. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Homemade Penetrating Fluid - the BEST you can use! DIY too
Top