TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
New Boat - Alumacraft 1648 NCS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="wmk0002" data-source="post: 414181" data-attributes="member: 13975"><p>I promise I will post some pics soon but I have been busy messing with my outboard. I am trying to convert my 9.9 hp long shaft to short. I thought it was going to be a simple procedure swapping my 15hp short shaft LU unit with the 9.9's longshaft one....but the 9.9 has some corrosion and the driveshaft is stuck in the motor. I'm letting some PB Blaster soak down the shaft into the splines. So I guess in the meantime I can get back to the boat.</p><p></p><p>I found a local building material store that carries 1 1/2" thick foam board so I am leaving work a little early to grab a sheet. And then stopping by TSC to get some of the stall mat they sell. Hopefully I can get that floor installed, my front seat pedestal base, and my motor converted to short shaft over the long weekend. This is one of those times when it's nice to have a second boat lol.</p></blockquote><p></p>
[QUOTE="wmk0002, post: 414181, member: 13975"] I promise I will post some pics soon but I have been busy messing with my outboard. I am trying to convert my 9.9 hp long shaft to short. I thought it was going to be a simple procedure swapping my 15hp short shaft LU unit with the 9.9's longshaft one....but the 9.9 has some corrosion and the driveshaft is stuck in the motor. I'm letting some PB Blaster soak down the shaft into the splines. So I guess in the meantime I can get back to the boat. I found a local building material store that carries 1 1/2" thick foam board so I am leaving work a little early to grab a sheet. And then stopping by TSC to get some of the stall mat they sell. Hopefully I can get that floor installed, my front seat pedestal base, and my motor converted to short shaft over the long weekend. This is one of those times when it's nice to have a second boat lol. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
New Boat - Alumacraft 1648 NCS
Top