Hey bud, great boat. I did a center console convert also. Check my profile for the build, it might give you some ideas for what you want to do. Best of luck with your project!!
Sweet build bud. I did the same thing by removing the middle bench seat. Be careful as removing the bench greatly reduces the structural integrity of the boat. Instead of wood I used 1/8" aluminum plate across the entire floor with rivits every 8 inches. It's a tank now, no flex in the removed...
The 1/8" plate will do the trick. I'm 280 lbs and there is very little flex. I stand on mine all the time. Just make sure you leave the foam in under the seat for support. If not, you should add 1 1/2" angle cross supports. So the seat frame doesn't sag over time.
Yes I did rivit to the existing front deck and removed the middle bench. I built the internal frame. The front seat is very sturdy as I added 1/8 plate across the entire front deck. The pictures give you the measurements you were looking for and how I ran the steering cable.
I do plan to rerun...
I have a 14/48 1972 Quachita that I bought this January. I did a full restoration with a center console convert. Check it out on my profile! Fantastic boat you have there!
q
No problem, I welcome corrective criticism! The reason for wood is I have no welder and to have it fabricated in this town would cost me an arm and a leg. The braces for the transom hold the current 25 Mercury with ease, in fact I looking to upgrade to a 50hp Yamaha and add pods. Pods would...