Search results

The clips to the rails are actually T joints that i cut a channel into. just slightly smaller than the rail so it clips on the rail instead of resting on it. worked well. we had lots of heavy snow this year and it held up very nicely.

Finally ran the boat last night! Not a single leak, we stayed high and dry. the boat sits level even with the rod locker full of poles and a small battery for the radio. with the 7.5 hp we were topping out at 10mph according to the GPS. doing a little plowing through the water with some spray...

thank you, we wanted to take out of this weekend but Kinzua Reservoir had a strong breeze and white caps so we didn't want to run it. the locker maybe weighs 15 pounds with the wood, carpet, glue. its not too bad I didn't anticipate it to cause any issue. once we get it on the water i will look...

Stewart, If they are well placed I can fit 6 rods in the locker. I cannot fit the 8 foot poles I have but they break down and I can stuff them at the very bottom.

there should be no reason to squeeze the bulb at WOT if the carb is set properly and everythign is functioning properly. Here's a thought, you could run the motor and low speed for a while, stop and drain the carb bowl - measure that amount of fuel. run the test again but at WOT for a while...

Still available? Do you have a picture? are you willing to ship it? thanks,

do I have any other options for props? something with a little higher pitch to get more speed?

Note to self: outboard motor does not double as a seat.

Ill take some measurements of mine tonight and post them. Do you mind taking some measurements of yours and we can compare?

Hi all, I purchased a 7.5 Johnson in the middle of summer last year, from the day i bought it i always thought the prop looks like the blades were almost flattened out with the tips of the blades almost pointing to the transom of the boat. is this normal? Shouldn't the tips of the blades be the...

remove the rear two benches. foam the floor and a sheet of plywood with some outdoor carpeting to keep it cheap.use your existing seats and these stands. will look good and give you versatility to move seats around

Finally got all the wiring done and cleaned the boat! used approximately 150Ft of wire to do it all. the second seat will be in today or tomorrow. Take a look and let me know what you think.

Where did you purchase the Geofoam? I cant find it anywhere online. The stuff looks cool, people have filled old in ground pools and put concrete over it to keep cost down.

a larger boat will also draw less water. (in a perfect world, when they all weigh the same)

is that a vinyl wrap? looks sharp

its going on a 14ft semi V conversion. 60 hp will be too much.

does anyone know about the Attwood Hydrostabilizar Jr? the fins aren't flat like traditional stabilizers. they have a slight upward angle, says the end comes out of the water when on plane to reduce drag...

Love the the long grass carpet. looks comfortable haha. let me know if you want to part with that evinrude. im running a 7.5 Johnson that i wouldn't mind upgrading.

It is pretty cool, from what i can tell they only made 1961-1962 in "cloud white" also. everything else was black.

Looking for a decent tiller for my boat. Let me know what you have. Preferably 1980's and newer. Thanks Sent from my SM-G920V using Tapatalk